USBASP AVR Programmer

Overview

USBasp is a USB in-circuit programmer for Atmel AVR controllers. It simply consists of an ATMega88 or an ATMega8 and a couple of passive components. The programmer uses a firmware-only USB driver, no special USB controller is needed. USBasp is a low-cost programmer for AVR micro controllers. It uses a pure software implementation of the USB communication protocol and it can be easily used with laptops.

Features

• Works under multiple platforms. Linux, Mac OS X, and Windows are tested.
• No special controllers or smd components are needed.
• Programming speed is up to 5 k Bytes/sec.
• SCK option to support targets with low clock speed (< 1,5 MHz).
• Planned: serial interface to target (e.g. for debugging).
• 10 pin ISP interface
• Allows you to read or write the micro controller EEPROM, firmware, fuse bits and lock bits
• Brand new and high quality
• Color: Black

Supported Microcontrollers

The programmer will work with a wide variety of Atmel AVR micro controllers

1. Mega Series
2. ATmega8 ATmega48 ATmega88 ATmega168 ATmega328
3. ATmega103 ATmega128 ATmega1280 ATmega1281 ATmega16
4. ATmega161 ATmega162 ATmega163 ATmega164 ATmega169
5. ATmega2560 ATmega2561 ATmega32 ATmega324 ATmega329
6. ATmega3290 ATmega64 ATmega640 ATmega644 ATmega649
7. ATmega6490 ATmega8515 ATmega8535
8. Tiny Series
9. ATtiny12 ATtiny13 ATtiny15 ATtiny25 ATtiny26
10. ATtiny45 ATtiny85 ATtiny2313
11. Classic Series
12. AT90S1200 AT90S2313 AT90S2333 AT90S2343 AT90S4414
13. AT90S4433 AT90S4434 AT90S8515
14. AT90S8535
15. CAN Series
16. AT90CAN128
17. PWM Series
18. AT90PWM2 AT90PWM3

Product Includes

• 1 x USBasp Device
• 1 x Ribbon Cable

Software

AVRDUDE supports USBasp since version 5.2.
BASCOM-AVR supports USBasp since version 1.11.9.6.
eXtreme Burner - AVR is a Windows GUI Software for USBasp based USB AVR programmers.

The Windows driver can be found in the downloads section.

Don't delay, buy today.

Add to cart now!